Getting everything setup:
1. Raise the suspension to get as much clearance as possible when going up the ramp and working under the car. Put wheel chaulks at the rear of the car.
2. Align the ramps with the front wheels, and put some cement blocks or anything heavy to prevent the ramps from sliding on the garage floor
3. Engage the emergency parking brake
4. Open the trunk by pulling the lever in the footwell beside the door
Tools and parts needed:
a. Socket wrenches 1/4″, 3/8″, 1/2″
b. T30 Torx bit
c. 12 Point XZN
d. triple square 12 point bit. size 8
e. Hex bit adaptor size 6mm
f. 34mm socket to remove filter housing
g. OEM filter replacement kit part number 079 198 405 D
h. full synthetic 0w40. 9 quarts to fill up
i. Crush ring N 013 815 7 VAG for drain plugRemove the panel underneath the car. Use the hex bit to remove the first drain by the driver sideRemove the drain plug with the hex bit from the oil filter canister
Tighten oil filter cannister 25 Nm
Remove the oil filter cap, and pour 9 quarts of oil.
Perform systems – reset service interval.
Warm up the engine and check the oil level using the MMI interface