S7 facelift rear lights. Dynamic/sweeping signal

$599 rear led tails from eBay

Modifications to lights:
– connectors have a tab that does not fit into the OEM connector.  took a flat head screw driver and heated it up over the oven and melted the tab off.  All 4 connectors to the OEM connectors will need to be melted off.

– splice into the 2 yellow wires on the inner and outer lights.  Use about 15 ft of stranded wire which will need to be wired from the inner to outer lights through the rear hatch.
– solder the 15 ft stranded wire with the 2 yellow wires that have been spliced.
– Use tape or insulation to protect the connection and wrap it up in cloth tape.

Removing the lights and hatch trim and pillar mounts
Outer tail lights:
– follow instructions here http://store.ijdmtoy.com/Audi-A7-LED-Reverse-Light-Install-a/694.htm

Inner tail lights:
– remove hatch trim by first taking off the 2 screws by opening the middle section
– pull on trim and it will pop off.  From here you should be able to see the rear tail lights and remove the connector
– lower the rear hatch, and raise the spoiler.  Under the spoiler you should use a plastic trim removal tool to pry up the two circlular covers where you can access two screws that need to be removed

VagCom > COMFORT MODULE > SECURITY > CODE:16017

Channel | Old | New

195 | 134 | 133
196 | 166 | 165
197 | 6 | 12
198 | 38 | 44
199 | | 51201
200 | 51233 | 51233
201 | 51201 | 51201
202 | 51233 | 51233
203 | 9 | 12
204 | | 44
205 | 13 | 13
206 | | 45
207 | 6 | 5
208 | 38 | 37
209 | | 51219
210 | | 51251

Comments are closed.