Changing brake pads on Toyota Highlander

Here are my the instructions on how to replace the brake pads on the Toyota Highlander.   Note that these are just my instructions and is no means the only safest way to perform this maintenance. Consult with a professional mechanic to ensure the proper steps and safety measures are followed.
This brake pad change was performed for the first time since purchasing the car brand-new. The car has 48,000 miles on it.

The first thing you need to do is take off the two bolts to the plastic panel underneath the front of the car which will give you access to the checkpoint.

https://drive.google.com/file/d/0B1s3vF9k5t0WNDRGazk2dGFQRXc/view

Jack up the car slightly and start loosening the lugnuts on one of the wheels.  Then jack up the car high enough so that there is clearance between the bottom of the tire and the floor. I think about 1 inch of clearance is good enough. From this point support vehicle by putting jackstands underneath the car. After this is completed take off all five lug nuts and remove the tire.
The next step is to take off the caliber. There will be two bolts near the back of the caliber that you will need to remove. Now take a piece of rope and tie the counter to the suspension of the car while removing it fall. Make sure you do not pinch the brake lines.

Remove the two V-shaped springs and take note of their location and fit. Next you want to remove the brake pads just by sliding in a screwdriver or even using your fingers to pry out the pads.

Remove the metal fittings from the original brake pads and place them on the new brake pads in the same orientation. Then apply some break grease only around the ends of the brake pads  where there will be contact and movement.

Place the brake pads back into the break housing in the same orientation as you took them out. Then take the V springs and place them in the brake pads to match the origin all orientation.
With a C clamp you will want to come press the brake caliper pistons and also use a 2 x 4 to help with the compression to avoid scratching or damaging the pistons.

After the Pistons I’ve been fully compressed remove the C clamp and 2 x 4 and apply grease to the Pistons. Only put a tiny amount. Remove the string tied to the caliper and place the caliper over the brake pads.

Insert and tighten the caliper bolts that were removed previously.

Leave a Reply

Your email address will not be published. Required fields are marked *